| Uploader: | Zuk |
| Date Added: | 12 December 2015 |
| File Size: | 70.56 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 93921 |
| Price: | Free* [*Free Regsitration Required] |
Drivers Download: Dl Driver Download
The User's Guide is well-written, but incomplete. Sometimes it works, sometimes it doesn't. Use windoes manual configuration instructions. It actually runs as a PCI-Express component. More often it doesn't. Working in Tumbleweed as of 21 July The RJ jack is the best I've seen on any board. AX driver support in kernel 2.
Larry More info is available on D-Link's web site. A CAT5 jumper cable snaps tightly into place. Realtek RTL too 8.
A diagram of the board would be nice. The back and front of the board are almost solid with ground and power planes; an indication of good engineering. Retrieved from " https: The network installation CD detects the network adapter and loads sky2.
It is detected and configured by yast and works until shutdown, but driver does not load on reboot. Detected as RTL compatible, kernel loaded module r, works without any problems.
10/100/1000 Gigabit Desktop PCI Adapter
The User's Manual agrees with my count. It's treatment on network cabling omits connecting two computers together with a cross-over cable, some of the basic installation rules e.
It costs a few more bucks than similar boards from other manufactures, but I would say the extra touches of quality are certainly worth the small premium. Bonding capable only tested under PCI-E x1 Card, the etx module in kernel-default-extra supported: You can actually do a completely net install by PXE booting from any nic, even if eindows kernel doesn't support that nic, and once booted, the installer will find the usb nic and use that for everything else.
Built-in NWay auto-negotiation detects 10 and Mhz connections and automatically supports half and full-duplex modes.
H16Bl-01 Downlaod
Net install works, but not PXE booting. It is NOT detected by hot plug. Tried Use the manual configuration instructions but doesn't seem to help. The network installation CD detects the network adapter and loads the correct module sk98 but it does not properly configure the adapter tested with version Installation was very easy with Windows 98 SE plug 'n prey as it should be: There is a bug in bios that stops the driver loading.
Network Install was not tested explicitly with this card but should work with no issue. This material or parts thereof may not be copied, published, put on the Internet, rewritten, or redistributed without explicit, written permission from the author. National Semiconductor DP Check with ethtool --show-offload eth0.
WOL can not be enabled and speed settings have to be passed as kernel module parameter.
Comments
Post a Comment